BSRXT - MIL-V-13811 B IGNITION VARNISH P/C 265-1100
- MSDS: BSRXT
- Manufacturer: PRESERVATIVE PAINT CO
- Product Name: MIL-V-13811 B IGNITION VARNISH P/C 265-1100
- National Stock Number: 8010-00-298-3870
Product Identification
Product ID:MIL-V-13811 B IGNITION VARNISH P/C 265-1100
MSDS Date:02/20/1991
FSC:8010
NIIN:00-298-3870
MSDS Number: BSRXT
Responsible Party
SEATTLE, WA 98108-1726
US
Emergency Phone: 800-424-9300 CHEMTREC
Info Phone: 206-763-0300
Cage: 86589
Contractor
Cage: 86589
Ingredients
XYLENE (SARA III) (VAPOR PRESSURE 21.0 MM HG @ 100F)
CAS: 1330-20-7
RTECS: ZE2100000
Fraction By Weight: 64%
ACGIH TLV: 100 PPM
EPA Report Quantity: 1000 LBS
DOT Report Quantity: 1000 LBS
5.05 LB/GL (606 G/L)
RTECS: 9999999VO
Hazards
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALATION: NOSE & THROAT IRRITATION.
NERVOUS SYSTEM DEPRESSION (HEADACHE, DIZZINESS, NAUSEA, STAGGERING,
CONFUSION & CONFUSION & UNCONSCIOUSNESS). SKIN: IRRITATION
(DISCOMFORT & DERMATITIS). ABSORPTI ON: BURNING SENSATION. EYES:
BURNING. INGESTION: GI DISTRESS.
Effects of Overexposure:(HEATH HZD) CENTRAL NERVOUS SYSTEM DEPRESSION,
CARDIOPULMONARY FAILURE, LIVER & KIDNEY DAMAGE & BIRTH DEFECTS.
CHRONIC: REPORTS ASSOCIATE REPEATED & PROLONGED OVEREXPOSURE
W/PERMANENT BRAIN & NERVOUS SYSTEM DAMAGE. UNDER NORMAL CONDITIONS
LOW LIKELYHOOD OF ADVERSE EFFECTS. OVERSPRAY/MIST:(NORMAL CONDITN)
NUISANCE DUST.
Medical Cond Aggravated by Exposure:PRE-EXISTING CONDITIONS INVOLVING
SKIN, LIVER, KIDNEY, AND PULMONARY DISORDERS.
First Aid
First Aid:EYE CONTACT: FLUSH WITH WATER FOR AT LEAST 15 MINUTES. CALL
PHYSICIAN. SKIN CONTACT: REMOVE CONTAMINATED CLOTHING & WASH
EXPOSED AREA WITH SOAP & WATER. INHALATION: REMOVE TO FRESH AIR. IF
NOT BREATHI NG, GIVE ARTIFICIAL RESPIRATION, PREFERABLY MOUTH TO
MOUTH. IF BREATHING DIFFICULTY PERSISTS OR OCCURS LATER, CONSULT
PHYSICIAN. IN UNLIKELY EVENT OF INGESTION, CALL DR IMMED. DON'T
INDUCE VOMITING.
Fire Fighting
Flash Point Method:TCC
Flash Point:79.0F,26.1C
Lower Limits:1.0
Upper Limits:7.0
Extinguishing Media:FOAM, CO2, DRY CHEMICAL, WATER FOG, OTHER
Fire Fighting Procedures:FULL PROTECTIVE EQUIPMENT INCLUDING SCBA AS
RECOMMENDED TO PROTECT FROM COMBUSTION BY PRODUCTS. COOL CLOSED
CONTAINERS WITH WATER TO PREVENT PRESSURE BUILDUP.
Unusual Fire/Explosion Hazard:KEEP CNTNR CLSD.VAPOR HEAVIER-AIR,TRAVEL
&COLLECT IN LOW SPOT.KEEP FROM HEAT,IGNIT.CLSD CNTNR MAY EXPLODE
W/HEAT.DON'T APPLY TO HOT SRFCS.SPONTANEOUS COMBUSTION
Accidental Release
Spill Release Procedures:VENT AREA. REMOVE ALL SOURCES OF IGNITION.
PREVENT SKIN CONTAT AND BREATHING OF VAPORS. CONFINE AND REMOVE
WITH INERT ABSORBENT MATERIAL. USE SPARK PROOF TOOLS.
Handling
Handling and Storage Precautions:OBSERVE LABEL PRECAUTIONS. KEEP AWAY
FROM HEAT, SPARKS & OPEN FLAME. KEEP CLOSURE TIGHT WHEN NOT IN USE.
STORE IN UPRIGHT POSITION TO PREVENT LEAKAGE.
Other Precautions:GROUND CNTNR WHEN POURING. DON'T STORE ABOVE 100 F.
KEEP & STORE OUT OF REACH OF CHILDREN. DON'T SAND, FLAME CUT, BRAZE
OR WELD DRY COATING W/OUT WEARING RESPIRATOR/VENT.EMPTY CNTNR
HAZARDOUS;HZD PREC AUTIONS APPLY. AVOID SPRAY DUST BUILDUP.
Exposure Controls
Respiratory Protection:PROPERLY FITTED VAPOR/PARTICULATE RESPIRATOR
APPROVED BY OSHA/MSHA.
Ventilation:SUFFICIENT IN PATTERN & VOLUME TO KEEP VAPORS BELOW
APPLICABLE OSHA REQUIREMENTS. USE EXPLOSION PROOF MECHANICAL EQUIP.
Protective Gloves:SOLVENT IMPERVIOUS GLOVES
Eye Protection:GOGGLES OR SAFETY GLASSES W/SIDE SHIELD
Other Protective Equipment:SAFETY SHOWER & EYEBATH. COVERALLS ARE
RECOMMENDED. A SOLVENT IMPERVIOUS APRON IS RECOMMENDED IF BODY
CONTACT MAY OCCUR.
Work Hygienic Practices:WASH CONTAMINATED CLOTHING BEFORE REUSE.
PERIODIC MONITORING OF EXPOSURE LEVELS/LIMITS IS RECOMMENDED.
Supplemental Safety and Health
Chemical Properties
HCC:F4
Boiling Pt:B.P. Text:139F,59C
Vapor Density:> AIR
Spec Gravity:0.9 (WATER=1)
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:NEGLIGIBLE
Appearance and Odor:CLEAR AND PIGMENTED COATINGS WITH CHARACTERISTIC
ODOR
Stability
Stability Indicator/Materials to Avoid:YES
MAY REACT WITH STRONG OXIDIZING MATERIALS.
Stability Condition to Avoid:NONE REASONABLY FORESEEABLE
Hazardous Decomposition Products:OXIDES OF CARBON
Disposal
Waste Disposal Methods:DON'T ALLOW MATERIAL TO CONTAMINATE GROUND WATER
SYSTEMS. ABSORB LARGE SPILLS WITH INERT ABSORBENT MATERIAL. DISPOSE
OF ABSORBED MATERIAL IN ACCORDANCE WITH FEDERAL, STATE & LOCAL
REGULATORY REQUIREME NTS. DON'T INCINERATE IN CLOSE CONTAINERS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.